We are WEE, We Enhance Efficiency

WEET 1.0 AMPS. MB1S THRU MB6S Glass Passivated Bridge Rectifiers
MB1S(50V),MB2S(100V),MB3S(200V),MB4S(400V),MB6S(600V)

The bridge rectifier MB6S and MB8S do not have a fixed output voltage, the output voltage is determined according to the input voltage, and the withstand voltage values of that component are 600V and 800V, respectively;
The bridge rectifier is to seal the rectifier in a shell. Divided into full bridge and half bridge. The full bridge seals the four diodes of the connected bridge rectifier circuit. The half bridge is to seal together half of the two diode bridge rectifiers. Two bridges can be used to form a bridge rectifier circuit. One half bridge can also form a full-wave rectifier circuit with a center tap of the transformer. Rectifier circuit and working voltage

Check more MB1S, MB2S, MB3S, MB4S, MB6S information at https://www.weetcl.com/Single_Phase_Bridge_Rectifiers/WEE_MBS_MB1S_THRU_MB10S.html 
datasheet: https://www.weetcl.com/pdf/WEET_MBS_MB1S_THRU_MB10S.pdf 

Skype, Email: info@weediode.com
Written by WEE Technology Company Limited

We are WEE, We Enhance Efficiency

WEET 1.0 AMPS. MB1S THRU MB10S Glass Passivated Bridge Rectifiers
MB1S(50V),MB2S(100V),MB3S(200V),MB4S(400V),MB6S(600V),MB8S(800V),MB10S(1000V)

The function of MB10S bridge rectifier is to work through the diode's unidirectional conduction principle. In general, the diode is forward-conducting and reverse-cut, that is, the diode only allows its positive pole to be positive and negative pole to be negative. The diode only allows the current to pass in one direction, so when it is connected to the AC circuit, it can make the current in the circuit flow only in one direction, so-called "rectification", with two tubes being half-pumped rectification, and four tubes being full-flow rectification.

Convert AC power to DC power, including half-wave rectification, full-wave rectification, and bridge rectification. The bridge rectifier encapsulates the four diodes of the bridge rectification and draws only four pins. Of the four pins, two DC outputs are labeled + or -, and the two AC inputs have a ~ mark. Apply the rectifier bridge to the circuit, mainly considering its maximum operating current and maximum reverse voltage.

Check more MB1S, MB2S, MB3S, MB4S, MB6S,MB8S,MB10S information at https://www.weetcl.com/Single_Phase_Bridge_Rectifiers/WEE_MBS_MB1S_THRU_MB10S.html 
datasheet: https://www.weetcl.com/pdf/WEET_MBS_MB1S_THRU_MB10S.pdf

Skype, Email: info@weediode.com
Written by WEE Technology Company Limited