WEE Technology Company Limited
We are WEE, We Enhance Efficiency
Manufacturer of Diode Rectifier, Bridge Rectifier, Transistor
WEET 15.0 AMPS GBPC15005 THRU GBPC1510 (GBPC15005, GBPC1501, GBPC1502, GBPC1504, GBPC1506, GBPC1508, GBPC1510)
Specification/Datasheet: https://weetcl.com/pdf/WEET_GBPC15005_THRU_GBPC1510.pdf
Manufacturer:WEET
Product Category:Bridge Rectifiers
Cerficates: RoHS,ISO
Type:Single Phase Bridge
Mounting Style:Stud Mount
Termination Style:Quick Connect
Package / Case:GBPC
If - Forward Current:15 A
Ir - Reverse Current:5 uA
Peak Reverse Voltage:GBPC15005-50V, GBPC1501-100V, GBPC1502-200V, GBPC1504-400V, GBPC1506-600V, GBPC1508-800V, GBPC1510-1000V
Vr - Reverse Voltage:GBPC15005-35V, GBPC1501-70V, GBPC1502-140V, GBPC1504-280V, GBPC1506-420V, GBPC1508-560V, GBPC1510-700V
Vf - Forward Voltage:1.1 V
Max Surge Current:300 A
Minimum Operating Temperature:- 55 C
Maximum Operating Temperature:+ 150 C
Length:28.8 mm
Width:28.8 mm
Height:7.87 mm
Series:GBPC1510
Packaging:Bulk
Unit Weight:17g
How to test bridge rectifier?
Use
the digital multimeter's diode or pointer meter 100 or 1000 to measure
the resistance between the two AC input terminals and the positive end
of the rectifier bridge output. If it is open or shorted, the rectifier
bridge is broken. Normal values should be 400 to 2000 ohms.
It
can also be measured that the resistance from the positive end to the
input end should be infinite, otherwise it is broken. The resistance
from the negative terminal to the input terminal should also be 400 to
2000 to be considered normal.
If the positive and negative DC
output voltages are not normal, you don't need to check the rectifier
diodes, but you can test the power transformer, because the possibility
of the same failure of several rectifier diodes is small.
When a
group of rectifier circuits fails, the fault detection method described
above can be used to check. In this circuit, the diodes VD1 and VD3, VD2
and VD4 of the rectifier diode are connected in parallel to the DC
circuit, and they will affect each other during the on-line detection,
so the accurate detection should disconnect the diode from the circuit.
more Bridge Rectifier: https://weetcl.com/Single_Phase_Bridge_Rectifiers/
Skype, Email: info@weediode.com
Written by WEE Technology Company Limited
